Connect over USB, then type a command, or pick one below.
Diagnostic mode is on, so launches aren't measured until you turn this off. Fit BX Tacho on the launcher, then press a button: empty with no top attached, loaded with a top attached.
Latest shoot power
Launch a top to see it here
- Shots
- –
- Best
- –
- Battery
- –
- Top
- –
Oldest on the left, newest on the right. Kept on BX Tacho, so it survives power cycles.
The same commands as over USB, without the cable: the way to run the battery calibration, which needs BX Tacho off USB power. Each time you connect, you enter the 6-digit code BX Tacho shows on its display.
Connect over Bluetooth and open the console to run commands.
Diagnostic mode is on, so launches aren't measured until you turn this off. Fit BX Tacho on the launcher, then press a button: empty with no top attached, loaded with a top attached.
Install a new bx-tacho-v….bin over Bluetooth, unlocked with the code on BX Tacho's display. It takes about a minute; then BX Tacho restarts into it. If anything goes wrong, it keeps its current firmware.